Page 6 For technical questions, please call 1-888-866-5797. Item 58781
SAFETY OPERATION MAINTENANCESETUP
Setup - Before Use (continued)
Assembly
Column to Base
1. Place Column Base (108) onto the Base
(109) and align holes in the Column
Base with holes in the Base.
2. Attach using Bolt (107) in each hole
through the Column and into the Base.
Column (104)
Base (109)
Column
Base (108)
Bolt (107)
Table to Table Support
1. Thread the Lock Handle (49) into the opening
in the Table Support bracket (50).
2. Lower the Table (42) into the Table Support
bracket and tighten Lock Handle to secure.
Lock
Handle (49)
Table
Support
Bracket (50)
Table (42)
Headstock to Column
1. With the help of an assistant, lift the Headstock
(86) above the Column, and gently slide it
down the Column as far as it will go.
Note: Make sure Set Screw (76) is backed
out enough to allow column insertion.
Headstock (86)
Column (104)
Set Screw
(76)
2. Align Headstock with Base.
3. Using a hex wrench, tighten Set Screw
(76) to secure the Headstock in place.
To Next Page
Loading...
