Page 8 For technical questions, please call 1-888-866-5797. Item 58781
SAFETY OPERATION MAINTENANCESETUP
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and unplug the tool from its electrical
outlet before performing any procedure in this section.
TO PREVENT SERIOUS INJURY:
DO NOT OPERATE WITH ANY GUARD DISABLED, DAMAGED, OR REMOVED.
Moving guards must move freely and close instantly.
Table Adjustment
1. Raise or lower the Table by loosening the rear Lock
Handle (49) and turning the Height Crank (102)
clockwise to raise and counterclockwise to lower.
Height
Crank
(102)
Lock Handle
(49)
2. Pivot the Table (42) around the Column by loosening
the Pivot Lever. The entire Table assembly and
Rack will move as one around the Column.
3. Tilt the Table by loosening the Adjustment Bolt
(51) and tilting to the required angle. The angle
can be read using the Angle Scale (97).
Adjustment
Bolt (51)
4. TO ENSURE THAT THE DRILL IS ENTIRELY
PERPENDICULAR TO THE TABLE,
insert a straight round bar (not included) in
the Chuck, place a square on the Table and bring it
up to the round bar. Adjust the angle as needed.
CAUTION! To prevent injury from
unexpected Table movement, tighten rear
Lock Handle (49) after adjustment.
Setting a Drilling Depth
Located against the Spindle Feed Shaft is a
Depth Gauge with a scale. The Gauge may
be locked in place by a Locking Knob.
1. Rotate the Depth Scale Knob until the
bottom of the knob is aligned with the
desired depth mark on the gauge scale.
2. Rotate the Lock Knob until it meets the Depth
Scale Knob. The chuck will stop after travelling
downward to the selected dis tance.
Lock
Knob
Depth Scale
Knob
Gauge Scale
To Next Page
Loading...
