Page 9For technical questions, please call 1-888-866-5797.Item 58781
SAFETYOPERATIONMAINTENANCE SETUP
Changing Drill Speed
1. Consult the table below to determine the
appropriate speed for the drill size being used.
Note: Drill press must be running
during speed change.
2. To adjust drill speed, simply raise or lower the Speed
Handle (17) until LED display shows desired RPM.
Note: If the Belt is too long to be properly
tensioned, it must be replaced.
Speed
Range
(RPM)
WOOD
Drill Bit Size
ALUMINUM/ZINC/BRASS
Drill Bit Size
IRON/STEEL
Drill Bit Size
IN mm IN mm IN MM
2000 - 3500 3/8 9.5 7/32 5.6 3/32 2.4
1400 - 2000 5/8 16 11/32 8.75 5/32 4
1000 - 1400 7/8 22 15/32 12 1/4 6.4
800 - 1000 1-1/4 31.75 11/16 17.5 3/8 9.5
200 - 800 1-5/8 41.4 3/4 19 1/2 12.5
The table above shows drill speeds for various materials used by this Press.
Drill Bit Installation
1. Insert the drill bit into the jaws of the Chuck
approximately 1″, ensuring that the jaws
do not touch the flutes of the drill bit.
2. Before tightening the Chuck, ensure that
the drill bit is centered within the jaws.
3. Tighten the Chuck securely with
the included Chuck Key.
To Next Page
Loading...
