Compliances
See end of Manual for compliance declarations.
Medical electrical equipment need special precautions regarding Electro
Magnetic Compatibility (EMC). It must be installed and serviced according to
the EMC guidelines.
Warning: Use of accessories, transducers and cables other than those
specified and sold with the device by the manufacturer as replacement parts
may result in increase of emissions or decrease of immunity of the device.
Warranty
BAUM Retec AG warrants the device, effective from the date of delivery, to be
free of any defects in material and workmanship. Warranty is not transferable
and does not apply to groups, multi users or agencies. This device has been
designed for the individual purchaser to be used in home or office
environments. BAUM Retec AG reserves the right to repair or replace with a
similar or better product. In no event shall BAUM Retec AG or its distributors
be liable for indirect or consequential damages. The original users’ remedies
are limited to replacement of devices modules/parts. This warranty is valid
only when service is done in the country of original purchase and with intact
warranty seals. For additional warranty claims or service during or after
warranty period, please refer to your distributor. BAUM Retec AG does not
take responsibility for use of this device other than described in this manual.
VisioBook has a limited 2 years warranty. Warranty on batteries is limited to 6
months.
Defects caused by improper use are not covered by warranty.
Defects and repair
If VisioBook is defective – what to do?
Did you check all settings and connections according to the manual?
Did you remove the protective plastic film from the camera lens?
Are you sure the mains outlet is live?
Do not use a broken device! Unplug broken device from mains! Please do not
hesitate to contact your local BAUM dealer or BAUM Retec AG.
You can reach BAUM Retec AG at telephone number (+49) 6223 4909-0 in
Germany. We will help you check your VisioBook and in case it is broken we
19
To Next Page
Loading...
