SWITCHING THE HEATING ELEMENTS
The cooking zones are clearly visible on the hob, being
circular.
Only the inside of the circles traced on the glass is
heated.
The hob has a built-in warning light that switches on when
the temperature in the cooking zone exceeds 60°C. This
warning light will only switch off when the temperature in
the cooking zone has gone below this value and it is for
this reason it is called the “residual heat warning”.
The heating elements with a single ccoking zone, are
controlled by energy regulators with 12 positions (E) that
permit to obtain a big range of different temperatures.
The heating element with a double cooking zone, are
controlled by 12-position energy regulators (F).
By turning the knob from 1 to 12, the powers of the rst
zone of cooking “1” are regulated. By turning besides the
number 12, a release it is warned that signals the insertion
of the second zone of cooking “2” (g. Y).
In this position, both work the zone of cooking to the
maximum power. By turning the knob counterclockwise
to regulate its power.
Only returning on the position “0” the second zone of
cooking is disconnected.
A red coloured warning light signals that the heating
elements are on.
To Next Page
Loading...
