15
Attheendofawashcycle,thetimedisplaywillflashfor8
seconds while the buzzer sound. However, when the delay
start funtion is activated, the time display will flash for
8 seconds, but the buzzer will not sound.
NOTE:Aclickcouldbeheardwhenthedoorisclosed perfectly.
When the washing is over, you can shut off the switch by
pressing ON/OFF button.
Open the door , press the ON/OFF button , and the ON/OFF light will turn on.
Pre
ss the "prog. "Button to select a desired "Wash cycle".(see
the section entitled."Wash Cycle Table".)
With a little force to ensure the door is properly closed.
5.
6.
When the washing is over, you can open the door and then shut off the swtich by
pressing on/off button..
7.
Turning on the Appliance
Premise: A cycle that is underway can only be modified if it
has only been running for a short time. Otherwise, the detergent
may have already been released, and the appliance may have
already drained the wash water. If this is the case, the detergent
dispenser must be refilled (see the section entitled " Loading the
Detergent " ).
Open the door,Press current prog. Button more than three
seconds to cancel the program ,then you can change the
program to the desired cycle setting Then, close the door
.
to start washing
NOTE: If you open the door when washing, the machine
will pause. When you close the door , the machine will
keeponworkingafter10seconds.
Starting a wash cycle...
1. Draw out the lower and upper basket, load the dishes and
push them back. It is commended that loading the lower
basket first, than the upper one (see the section entitled
“Loading the Dishwasher”).
2. Pour in the detergent (see the section entitled “Salt,
Detergent and Rinse Aid”).
4. Insert the plug into the socket. The power supply is 220-240
VAC 50 HZ, the specification of the socket is 12 A 250 VAC.
Make sure that the water supply is turned on to full pressure.
3.Turn on the water supply to full pressure.
To Next Page
Loading...
