Baumatic BFD46 - Page 28

BAUMATIC BFD46W dishwasher user manual
PERFORMANCE. (GO BACK AND LOOK
YOUR DISHWASHER MUST BE
27
e) THEN, APPLY THE CONDENSATION STRIP.
The Condensation Strip must be fitted to the
underside
of the worktop above your dishwasher
to
protect it against any moisture. Its purpose
is to deflect steam rising from your appliance to
protect
your worktop’s underside.
• The strip is located inside your
dishwasher.
• Ensure the surface is clean prior to
sticking
to underside of the worktop.
• Separate the backing paper from the
strip.
• Stick to the underside o f the worktop.
Note: Fai l ure to attach strip could
resu
lt in damage to the underside
of
your work surface!
f) NOW YOU ARE READY TO PUSH THE
DISHWASHER INTO POSITION
(SEE FIGURE BELOW):
NOTE
–
MAKE SURE YOU HAVE THE
DISHWASHER
ON ITS SLIDE
RAILS
(SEE ILLUSTRATION ON
RIGHT
).
* Note *
You can detach the top board
(5)
that comes as part of your
dishwasher
if you want to
install your dishwasher in your
cabinet.
THEN MOVE IT INTO THE
CABINET RECESS (AS
PICTURED ON RIGHT, 6-7 ),
ENSURING
THAT IT IS BACKED
UP
AGAINST THE WALL.
g) ENSURE THAT YOUR DISHWASHER IS LEVEL
IN ITS NEW POSITION
.
NOTE:
OPERATION AND WASH
LEVEL FOR PROPER DISH RACK
27