Baumatic BFR6 - Completing the Installation

o Slide chimney section (D) inside of chimney section (C). Then
secure the upper bracket (plate II) to the wall, using the same
method as you have just used to secure the lower bracket (plate I).


13) Lift chimney section (D) up to the ceiling and secure it to the
bracket (plate II) using the screws provided.
Plate II
Rawl plug
Screw (4mmx8mm)
Screw
(4mmx30mm)
Completing the installation
o If you are setting the appliance to recirculation mode, then you
should now fit the two carbon filters. See the “Fitting the carbon
filters” section on page 14.
o The electrical connection must correspond to the electrical
requirement noted on the rating plate, which is placed inside the
rangehood. The appliance can now be connected to the electrical
supply. See page 15 for detailed information on the electrical
connection.
o Use a stainless steel cleaner and polish on the stainless steel
sections of the appliance. This will help to remove fingerprints.
o Refit the grease filters and then switch on the mains
supply to the appliance. Check that the appliance is
operating correctly by selecting each speed and
switching the light bulbs on and off.
23