INSTALLATION
on must be carried out by a suitably
o AS/NZS 3000: 2007 Wiring Regulations
afety Regulations
lectrical connection
o
o
voltage.
THED.
uld be wired into a 13 A double pole switched
fused spur outlet, having 3 mm contact separation and placed in
ousing.
inside. Make the connection, securing the cord in place with the
cable clamp provided and then immediately close the terminal
block cover again.
o If you have to change the oven power cord, the earthing
ot exceed 50°C.
nt.
The installati
qualified person, in accordance with the current
version of the following.
o 2010 Electricity S
E
Before c
marked
nnecting the appliance, make sure that the supply voltage
n the rating plate corresponds with your mains supply
WARNING: THIS APPLIANCE MUST BE EAR
o This appliance sho
an easily accessible position adjacent to the appliance. The spur
outlet must still be accessible even when your oven is located in
its h
o To connect the oven power cord, loosen and remove the cover
on the terminal block, in order to gain access to the contacts
(yellow/green) conductor must always be 10 mm longer than the
line conductors.
o Care must be taken to ensure that the temperature of the mains
supply cable does n
o If the mains supply cable is damaged, then it must be replaced
by an appropriate replacement which can be obtained from the
Spares Departme
18
To Next Page
Loading...
