Connecting to the mains water supply
9 The water inlet hose will be inside the drum of your washer dryer,
when you receive the appliance.
9 Connect and fully tighten the inlet hose to
the threaded inlet valve that is located at
the rear of the washer dryer. You should
connect the end with the right angle
connector on it to the back of your
appliance.
9 Connect the other end of the inlet hose to your mains
water supply
9 IMPORTANT: There should be a filter sitting inside the end of the
inlet hose that connects to your mains water supply. The inlet hose
may leak if this filter is missing. This filter is supplied with the
appliance, you should contact Baumatic to obtain one, if it is
missing.
9 Tighten the inlet hose to your mains supply fully, but do not over
tighten as this may distort the filter that sits in the end of the inlet
hose.
9 Test for any leaks.
33
To Next Page
Loading...
