21
Wash only
o Put the laundry into the drum and put detergent and softener
into the detergent drawer. Then close the door.
o Press the power button (1) and the LED will show only “---“.
o Select the wash course you want by pressing the wash button
(6). The temperature will automatically be set to ‘cold’.
o Press the start-pause button (2) and the washer will be
operated with a locked door and supplied water.
Drain
• Press the power button (1), the LCD display will show “---“ and
all the program lights will come on.
• Use the wash program selection knob (3) to select the drain
program.
* Press the start/pause button (2), the door will lock and after a
few seconds you will hear the machine start to drain.
* IMPORTANT: Please note that the appliance will not spin on this
particular wash cycle.
Tub clean program
o Press the power button (1) and the LED will show only “---“.
o Select the tub clean program using the program selection dial
(3). The machine will automatically set a soak program and a
spin speed of 400 rpm and a ‘cold’ water temperature.
Rinse + Spin program
o Put your laundry into the drum. Put softener into the detergent
drawer and close the door. The softener level should be below
the ‘MAX’ level.
o Press the power button (1). The LED will display only “---“.
o Press the rinse + spin button (7) and an 800 rpm spin speed
with a ‘cold’ water temperature will be automatically selected. If
you want to change the spin speed, press the spin button (5).
You can also alter the water temperature using the temperature
button (4).
To Next Page
Loading...
