22
o Press the start/pause button (2) and the washer begin operating
after the door is locked.
End of cycle
o At the end of a wash cycle, the door lock light will remain lit for a
couple of minutes.
o IMPORTANT: You should not attempt to open the porthole door
until the door lock light has gone out.
o When the door lock light has gone out and you hear the door
lock disengage, you can open the porthole door and remove the
laundry.
Pausing a wash program
o If you want to pause a wash program temporarily, you should
press the start/pause button (2).
o When you want to restart the wash cycle, press the start/pause
(2) button again.
Changing a wash program
o If you want to change a wash program once the wash cycle is
already in progress, you should first press the start/pause button
(2).
o Use the wash program selection knob (3) to change the wash
program to the one that you require.
o IMPORTANT: Changing the wash program will cancel any spin
or temperature alterations that you have made and any program
options that you have selected. You will need to make the spin/
temperature alterations again and re-select any program options
that you require.
Delay start feature
Your appliance has a delay start feature, which allows you to delay the
start of a wash cycle until a later time.
o Put the laundry into the drum and close the door.
o Put the detergent into the main wash compartment and prewash
compartment in the detergent drawer. Softener should be below
the ‘MAX’ level. Only put detergent into the prewash
compartment if you want to add a prewash to your cycle.
To Next Page
Loading...
