23
o When you want to use bleach put this in the main wash
compartment with the detergent.
o Press the power button (1) and the LED display will show “---“.
o Press the delay start button (9). If you press the start/pause
button (2) next without selecting a program, the cotton wash is
selected as a default wash cycle.
o Alternatively you can select a wash using the wash program
selection dial (3) and you can also alter the temperature (4)
and spin speed (5) by pressing the relevant buttons.
o Select the time delay you require by pressing the time delay
button (9). You can choose between 2 to 12 hours and the
displayed time will show the program’s finishing time. The
finishing time may vary depending on your selected
temperature.
o Press the start/pause button (2). The time delay LED should
light.
o The delicate, quick-20, tub-clean and drain programs cannot be
selected using the time delay function. You also cannot add
clothes during a time delay cycle.
Child lock
Your appliance has a child lock option, if this is set, it will mean that
nobody can affect the operation of the wash program once it has
started.
o To activate the child-lock, press and hold the wash button (6)
and the temperature button (4) at the same time for
approximately three seconds.
o Follow the same steps to deactivate the child-lock.
Maintenance and cleaning
In daily use
o Once a wash cycle has completed, you should pull out the
detergent drawer slightly, so it can dry out.
o Leave the porthole door ajar for a short while after a wash cycle
has completed. This should help to prevent stagnant smells and
to protect the door seal.
To Next Page
Loading...
