IMPORTANT: Your appliance has an unbalance control system.
If this system detects that the washload is unevenly distributed
inside the drum. Your washing machine will try to redistribute
the load before spinning. If after several attempts it is unable
to redistribute the washload, then the appliance will either spin
at a slower speed or skip the spin cycle and proceed to the
drain section of the wash cycle.
Uneven load distribution can be caused by too large a wash
load or too small a wash load. It can also occur if a single item
if washed inside the appliance.
IMPORTANT: If your appliance appears not to be
operating correctly, then you should disconnect it
from your mains supply and then contact the
Customer Care Department on telephone number
(0118) 933 6911.
DO NOT ATTEMPT TO REPAIR THE APPLIANCE
YOURSELF.
Please note that if an engineer is asked to attend whilst the product is
under guarantee and finds that the problem is not the result of an
appliance fault, then you may be liable for the cost of the call out
charge.
The appliance must be accessible for the engineer to perform
any necessary repair. If your appliance is installed in such a
way that an engineer is concerned that damage will be caused
to the appliance or your kitchen, then he will not complete a
repair.
This includes situations where appliances have been tiled in,
sealed in with sealant, have wooden obstructions placed in
front of the appliance, like plinths. Or any installation other
than the one specified by Baumatic Ltd. has been completed.
Please refer to the conditions of guarantee that appear on the
warranty card that you receive with the appliance.
IMPORTANT: Baumatic Ltd. operates a policy of continuous
improvement and reserves the right to adjust and modify its
products without prior notification.
38
To Next Page
Loading...
