29
My appliance isn’t working correctly
Error codes
Error code Possible causes Solution
F0/F1/F2 Fan failure Contact the Baumatic
Service Department
F3 – F8 Temperature sensor
failure
Contact the Baumatic
Service Department
E1/E2 Abnormal supply
voltage
Check that the power
supply the hob is
connected to is
appropriate. (See the
diagram on page 27).
E3/E4 High zone
temperature
Allow the hob to cool
and then restart it. *
E5/E6 High hob temperature Allow the hob to cool
and then restart it. *
* IMPORTANT: If these error codes appear frequently, then check
that the installation of the hob has been completed correctly. In
particular, pay attention to the ventilation requirements specified in
this manual.
o The cooking zones are not functioning or will not switch
on.
* It has been more than two minutes since the appliance was
switched on. You should switch the appliance on again, using the
ON/OFF button.
* You have not placed an appropriate pan on the zone that you are
trying to get to heat.
* The safety lock has been switched on (see the “Switching on the
safety lock” section for information on how to turn off the safety
lock).
* Several touch control buttons have been pressed at once. You
should only touch one touch control button at a time.
* The safety cut out has been triggered. Press the ON/OFF button
(9) to reset the appliance.
* Check that the mains electrical supply to the appliance is correct
and working. Check the mains fuse.
To Next Page
Loading...
