TAM 00609 10
DA 100 – 280 03 / 2015
Three phase asynchronous motor air cooled Englisch
Vibration-proof DA100 radial 0,5 g/axial 0,5 g, 10 Hz - 150 Hz (acc. to EN 60068-2-6)
Vibration proof DA132 - DA280 to radial 3 g/axial 1 g, 10 Hz - 55 Hz (acc. to EN 60068-2-6)
Holding brake Option
Actual speed encoder Standard: 2-pin resolver
Option: Sincos encoder
For further technical values, please refer to our technical product list DA 100 - 280 on the website
of www.baumueller.de in the download area – technical documents. Please, contact us for the ac-
cordant documents, if required.
CAUTION!
If the electric motor supplied is not a standard version in accordance with the technical documentation or if
special arrangements were contractually agreed, the technical data may differ to the values stated in these
Commissioning and Maintenance Instructions. The supplementary technical details are available on request.
Transport, intermediate storage 2.5
Transport:
Suitable load suspension material must be used, such as belt webbing, loop belts etc. If provid-
ed, the lifting lugs of the motor can be used for lifting.
The terminal boxes or motor connectors must not be used as shipping braces or lifting lugs.
The regulations in the respective countries must be adhered to during transport. Lifting devices,
transport and load suspending devices must comply with the regulations.
The Baumüller electric motors of the “DA...” series weigh up to approx. 1,400 kg. Precise details relating to
the weight of the respective devices can be found in the technical documentation.
The motor shaft and the connection surfaces must be protected against corrosion. The motor must be trans-
ported with motor shaft covering to prevent unnecessary damage to the motor shaft.
Air inlet and outlet openings must be covered to prevent any foreign matter ingress into the fan during
transport.
Bearing security (at motors with cylindrical roller bearings only)
In order to avoid transportation damages the motors with cylindrical roller bearing of
the rotors are blocked by means of transport safety devices at the shaft end.
For further transports this transport safety must be used again.
In case this safety device cannot be used anymore due to the addition of a drive ele-
ment then other suitable measures must be made to fix the axes of the rotor during the
transport.
Intermediate storage:
If a motor is not to be commissioned immediately after delivery, it should be stored inside a building in a dry,
dust-free and low-vibration room (V
eff
= 0.2mm/s).
The electric motors should not be stored for more than two years at a preferably constant tempera-
ture between -30°C to +60°C. Higher storage temperatures within the service temperature will ac-
celerate the ageing of gaskets and the bearing greases and therefore affect the service life already
before the commissioning negatively. . Direct exposure to incident solar radiation, UV light and ozone can
also lead to an ageing of the gaskets and must be avoided!
Please note that the warranty periods commence from the date of delivery. For this reason, we recommend
that storage periods be reduced to a minimum.
To Next Page
Loading...
