TAM 00609 5
DA 100 – 280 03 / 2015
Three phase asynchronous motor air cooled Englisch
Designated use 1.2
The electric motor must only be used for its designated purpose. In this context, the electric motor must only
be used for the applications described in this technical documentation under strict observance of all the notes
in these Commissioning and Maintenance Instructions.
All assembly, commissioning, maintenance and operating tasks must be carried out by qualified personnel on-
ly.
Within the context of these safety instructions, qualified personnel refers to persons who are trained and au-
thorized in the specialized area, who are authorized to set up, assemble, commission and operate devices,
systems and circuits under application of the applicable safety standards (EN 50110-1).
Inappropriate action can cause serious damage to persons and property.
The electric motor is designed for use in industrial applications and is subject to the following stand-
ards and directives:
Standards
EN 60034-1, EN 60034-5, EN 60034-6, EN 60034-7, EN 60034-9, EN 60034-11,
EN 60034-14, EN 60204-1
Low Voltage Directive 2006/95/EG
The electric motors in this series comply with the requirements of the Low Voltage Directive
2006/95/EG (conformity).
Machinery Directive 2006/42/EG
Electric motors are components to be installed in machines for installation in machines defined in the
Machinery Directive. Commissioning is not permitted until the conformity of the finished product with this
directive has been established (refer to EN 60204-1 “Electrical Equipment of Machines”).
EMC Directive 2004/108/EG
The operation of the electric motor in its intended use must comply with the protective requirements laid
down in the EMC Directive 2004/108/EG. The person setting up the system is responsible for the cor-
rect installation (such as spatial isolation of signal lines and power cables, screened lines and cables
etc.). In the case of systems with converters, the EMC notes of the manufacturer of the converter must
also be observed.
All national, local and system-specific regulations must also be observed
The electric motor is designed for the following ambient conditions:
• Ambient temperature: 0 °C to +40 °C
• Installation height: 1,000 M ASL
• Relative humidity: 10 % to 80 %
Condensation water must not be allowed to accumulate.
Please take note of any deviating details specified on the type plate or in the technical documentation.
The conditions at the place of utilization must correspond to the details on the rating plate
Utilization in hazardous areas is prohibited, unless the unit is designed for this purpose (refer
to additional notes). Furthermore, the area surrounding the electric motor must be free of in-
flammable gas mixtures and concentrations of dust. Live and hot motor parts are inflammable
and may cause serious injury and damage to property.
If, in special cases, greater requirements are placed – for utilization in non-industrial applica-
tions – (such as protection against contact with a child’s fingers), these conditions must be by
the customer met when installing the system.
To Next Page
Loading...
