Baumuller DA 100 - Tests Prior to Commissioning; Commissioning, Operation

TAM 00609 16
DA 100 – 280 03 / 2015
Three phase asynchronous motor air cooled Englisch
Tests prior to commissioning 4.2
The drive is undamaged and is not located within the danger zone of other equipment
• The motor is correctly aligned and fixed. All screwed connections are correctly tightened.
• All the appropriate safety devices (mechanical, thermal and electrical) are mounted.
• The motor connections have been carried out correctly.
• The protective conductor system is correct and its functionality has been checked.
• The lines and cables do not come into contact with the motor surface.
• The drive does not block (release brake, if applicable).
• Emergency OFF functions have been checked.
• The fan has been properly connected and its functioning checked.
• The direction of fan wheel rotation is identical to the identified direction of arrow.
Commissioning, operation 4.3
Notes on the brake function (if provided):
The brake is a holding brake with an emergency STOP function (power failure, emer-
gency stop)
The brake may not be used as a working brake.
The commissioning must be carried out by qualified personnel, only.
Please refer to the commisioning instructions for the converter.
Tests during commissioning:
• Release brake if required.
• Has the functionality of all motor modules such as the brake, encoder, cooling system been checked and
are the operating conditions observed?
• Have all electrical connections been carried out and fixed as required by the regulations (refer to wiring di-
agrams)?
• Have all protection measures that eliminate the possibility of contact with live parts, hot surfaces, rotating
and moving parts been observed and are these measures fully functional?
• Have all output elements been mounted and set in accordance with the manufacturer’s instruc-
tions?
• Was ensured that the maximum permitted speed n
max
of the motor is not exceeded? The maxi-
mum permitted speed n
max
ist the highest short-term allowable operation speed.
Tests during operation:
Watch out for unusual noises.
• If scraping, scratching or grinding noises occur, stop the motor immediately and locate the cause.
• Check the motor surface and connection cables for dirt, such as layers of dust, oil deposits, dampness
and leaks etc.
• Check air inlet and outlet openings and any interposed filters for dirt accumulation
• Check the maintenance intervals.