TAM 00621 5
DSD 45-100 05/2007
Three-phase synchronous motor English
1.2 Designated purpose
The electric motor must only be used for its designated purpose. In this context, the electric
motor must only be used for the applications described in this technical documentation under
strict observance of all the notes in these Commissioning and Maintenance Instructions.
All assembly, commissioning, maintenance and operating tasks must be carried out by qualified
personnel only.
Within the context of these safety instructions, qualified personnel refers to persons who are
trained and authorized in the specialized area and who are authorized to set up, assemble,
commission and operate devices, systems and circuits under application of the applicable
safety standards (IEC 364 / DIN VDE 0105).
Inappropriate conduct can result in serious personal injury and damage to property.
This electric motor has been designed for use in industrial applications
and is subject to the
following standards
and directives:
Standards
EN 60034-1, EN 60034-5, EN 60034-6, EN 60034-7, EN 60034-9, EN 60034-11, EN 60034-
14, EN 60204-1
Low Voltage Directive 2006/95/EC
The electric motors in this series fully comply with the requirements of the Low Voltage
Directive 2006/95/EC.(Conformity)
Machinery Directive 98/37/EC
Electric motors constitute components for installation in machinery as defined by the
Machinery Directive. Commissioning is not permitted until such time as the conformity of the
finished product with this directive has been demonstrated (EN 60204-1 "Electrical Equipment
of Machines").
EMC Directive 89/336/EEC
The operation of the electric motor for its designated use must comply with the protective
requirements laid down in EMC Directive 89/336/EEC. The person setting up the system is
responsible for ensuring correct installation (e.g. physical separation of signal lines and power
cables, screened lines and cables, etc.). In the case of systems featuring power converters,
the EMC notes of the power converter manufacturer must also be observed.
All national, local and system-specific regulations must also be observed!
The electric motor has been designed for the following ambient conditions
:
• Ambient temperature: 0°C to +40°C
• Altitude: ≤1000 m above sea level
• Relative humidity: 10% to 80%
Please take note of any discrepancies between this information and the details specified on
the nameplate or in the technical documentation. The conditions at the place of use must
correspond to the details on the rating plate.
To Next Page
Loading...
Need help?
General
