EasyManuals Logo

Baxi Nuvola 3 BS 280 Fi User Manual

Baxi Nuvola 3 BS 280 Fi
Go to English
224 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #38 background imageLoading...
Page #38 background image
38
7113868.01 - en
INSTRUCTIONS FOR USERS
9. TROUBLESHOOTING
To keep the boiler efcient and safe, have it checked by the authorised Service Centre at the end of every operating period.
Careful servicing ensures economical operation of the system.
Do not clean the outer casing of the appliance with abrasive, aggressive and/or easily ammable cleaners (i.e.: gasoline, alcohol,
and so on). Always isolate the electrical supply to the appliance before cleaning it (see section 6).
10. ROUTINE MAINTENANCE INSTRUCTIONS
CODE
DISPLAYED
TYPE OF FAULT
CORRECTIVE ACTION
E01 Ignition failure
Press . If this fault persists, call the Authorised Service
Centre.
E02 Safety thermostat tripped
Press . If this fault persists, call the Authorised Service
Centre.
E03
Flue thermostat/ ue pressure switch
tripped
Call an authorised Service centre.
E04 Safety error due to frequent ame loss
Call an authorised Service centre.
E05 Delivery sensor fault
Call an authorised Service centre.
E06 DHW sensor fault
Call an authorised Service centre.
E10 Hydraulic pressure switch block
$IFDLUIBUUIFQSFTTVSFJOUIFTZTUFNJTDPSSFDU4FF
section 5. If this fault persists, call the Authorised Service
Centre.
E11
Safety thermostat for low temperature
system cuts in (if connected)
Call an authorised Service centre.
E25 No water safety trip
Call an authorised Service centre.
E31
Communication error between electro-
nic board and remote control unit
Press . If this fault persists, call the Authorised Service
Centre.
E35 Parasite ame (ame error)
Press . If this fault persists, call the Authorised Service
Centre.
E98 Internal board error
Call an authorised Service centre.
E99 Internal board error
Call an authorised Service centre.
Faults are shown on the display with an error code (e.g.: E01):
The faults that can be reset by the user ar
e indicated on the display with the symbol
(gure 4).
The faults that cannot be reset by the user are indicated on the display with the symbol
(gure 4.1).
To RESET the boiler, press and hold down
for at least 2 seconds
.
Figure 4
0710_0201
Figure 4.1
0605_1107

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Baxi Nuvola 3 BS 280 Fi and is the answer not in the manual?

Baxi Nuvola 3 BS 280 Fi Specifications

General IconGeneral
BrandBaxi
ModelNuvola 3 BS 280 Fi
CategoryBoiler
LanguageEnglish

Related product manuals