– 16 –
Clean and Vacuum Components and Control/Burner Areas
1. Clean the control/burner compartment (Fig. 3) area of dust and/or lint accumulation.
2. Vacuum the control/burner compartment floor of dust and/or lint accumulation.
3. Gain access to the top of oven and clean dust that may have accumulated on top of circulation
blower motor (Fig. 4).
4. Clean cabinet blower screen located at top of the control compartment (M2B only).
Fig. 3
Fig. 4
Inspect Rack Lift and Rotation Assemblies
1. Check rack lift assembly for proper operation.
A. Open door. Rack lift should lower to correct height of rack and be in forward loading position
to accept rack entry.
B. The oven rack should be easily rolled in and out of oven and the wheels completely off the
oven floor when raised.
2. Check and tighten all set screws on carrier.
To Next Page
Loading...
