Why can't STEAM TIME be set above 10 seconds on my Baxter oven?
If the STEAM TIME on your Baxter oven cannot be set above 10 seconds, and the time increments by 1-second, it means the oven is in Food Service or Pulse steam mode. Refer to the Food Service Mode instructions to switch the oven back to Bakery mode.
What does ‘SHdn’ mean on my baxter OV500 Oven display?
If your Baxter oven display shows ‘SHdn’, it indicates that the Safety Alarm has disabled the oven. Turn off all power and gas to the oven and contact your local Baxter authorized service office.
What does ‘LOC OUT’ mean on my baxter OV500 display?
If the display on your Baxter oven shows 'LOC OUT,' it means the oven is in Kosher Lock-Out Mode. Contact your local Baxter authorized service office.
How to fix burners that will not light on a Baxter gas oven?
If the burners on your Baxter gas oven won't light, try the following: Ensure the loading door is fully shut, making sure the door switch is activated. If that doesn't work, press the OFF button, wait 5 minutes, then ensure both the gas shutoff valve and the gas valve are in the ON position. Finally, press the ON button to restart the oven.
Why does my baxter OV500 Oven temperature display change between a number and ‘COOL’?
The Baxter oven display alternates between a number and 'COOL' because the Cool Down mode is active. To return to normal mode, simply close the oven door or press any button.
What to do if my Baxter oven control beeps continuously?
A continuous beep from the Baxter oven control indicates a Rack Rotation alert. First, check that the rack is indeed rotating. Next, inspect for any pans that might be protruding from the rack. If the beeping continues after these checks, contact your local Baxter authorized service office.
What does it mean when my baxter OV500 display is flashing with no beeping, while in a timed bake cycle?
The flashing display on your Baxter oven, without any beeping during a timed bake cycle, signifies a temperature recovery alert. To resolve this, open and then close the oven door to reset the heat control. If the unit still doesn't begin heating, contact your local Baxter authorized service office.
Why does my baxter OV500 circulation fan run when the oven is turned off?
If the circulation fan in your Baxter oven continues to run after the oven is turned off, it means the oven is in Cooling mode. To cancel this mode, close the oven door. If the door was not open and the fan continues to run, contact your local Baxter authorized service office.
What does it mean when my baxter OV500 Oven controls beeps rapidly?
Rapid beeping from the Baxter oven controls (faster than the Baker Timer) indicates a temperature alert for Kosher Mode. If the vent is on, turn it off. For gas ovens, check that the burner is firing; if it isn't, briefly open and close the door to reset the temperature control.
Why doesn't the rack lift and rotate in my Baxter oven?
If the rack in your Baxter oven isn't lifting and rotating, ensure that bake time has been entered into the timer and that the timer has been started. Enter the time in the TIMER and press START. If the problem continues, contact your local Baxter authorized service office.
Details the functions and display of the oven's digital control panel.
Explains the oven's safety alarm system, its triggers, and actions.
Procedures for safely shutting down and restarting the oven.
Troubleshooting steps for gas ovens when burners fail to ignite.
Explains common alarms and display messages and their causes/actions.
To Next Page
General
