– 21 –
SHUTDOWN
NOTE: Before restarting a gas oven, the power switch and the gas burner valve must be o for a minimum
of 5 minutes.
1. Remove all remaining product.
NOTE: Vent can be used to evacuate steam from oven.
2. Allow the oven to cool, then press the POWER ON/OFF button. If desired, quicker cool down time
can be accomplished through the use of the COOL DOWN button.
3. Clean the baking chamber. See Cleaning page 23.
4. For lengthy shutdowns, disconnect the main power and shut o the gas and water supply.
RESTARTING OVEN
NOTE: Before restarting a gas oven, power switch and gas burner valve must be o for a minimum of
5 minutes.
1. Press the POWER ON OFF button to turn the oven on.
2. Press the UP or DOWN arrows next to the SET TEMP window to enter the desired temperature.
PERFORM LED DISPLAY TEST
1. Switch the oven into the o mode.
2. Press and hold the VENT button then press and hold the POWER ON OFF button until you hear a
beep and see the rst test pattern.
The test will cycle through various LED tests. After the test has completed, it shall go back to showing the
regular display along with the clock and it shall beep once.
UPDATE OVEN APPLICATION FIRMWARE VIA USB DRIVE (For Use on Ovens Supplied with
USB Connection Package)
1. Switch the oven into the o mode.
2. Insert the ash drive that contains the rmware
binary le [FIRMWARE.BIN] into the USB socket.
3. Press and hold the STOP button then press and
hold the POWER ON OFF button, keep holding
both buttons until word ‘UPdt’ [Update] is displayed
in the clock eld.
When the rmware has nished being updated the display
shall show UPDt-done [Update done]. You need to power
o the oven, wait 10 seconds and then power on the oven
to make it operable again.
If no binary le, Firmware or Recipe, is found, the display
will show:
UPdt-FAIL-USb-Err [Update fail USB error]
To correct this error, insert the correct USB drive and
power o and then power on the oven.
To Next Page
Loading...
Need help?
General
