– 13 –
The next screen shows the
program for the second day
after the NEXT button is pressed
(Fig. 18).
INACTIVATE Program >
[EXIT] [NEXT]
Monday Program is
ACTIVE (will proof)
Review/Edit Settings>
Start Retard/Proof>
CHANGE MODE>
RETARDER/PROOFER
After a 7-day program is nished, the
LCD displays the nal message as
shown in Fig. 19.
The operator has two options, either
to review/edit new change or go back
to other operation options (manual
Retard or manual Proof) by pressing
"CHANGE MODE" arrow button.
Otherwise, the auto Retard/Proof
operation will start after the arrow
button is pressed as shown in Fig. 19.
Again, the LCD displays a choice of the next day program by activating or deactivating the program button.
To skip the next day, the next day program must be inactive. Then press NEXT button. If next day program
is activated, then proceed with similar steps as shown in screen shot Fig. 11 through Fig. 17.
Fig. 18
Fig. 19
Press here to activate or
deactivate the program.
Press here to activate the auto Retard/Proof.
Press here to go to manual Retard or Proof.
To Next Page
Loading...
Need help?
General
