– 20 –
FORM 36756 (Feb. 2019) PRINTED IN U.S.A.
MAINTENANCE
Disconnect the electrical power to the unit and follow lockout / tagout procedures.
Every 6 months have authorized service personnel check air duct, drain, heater plate, spray nozzle and
refrigeration coils (if applicable).
LIGHT BULBS
Replace light bulb(s) with 40-watt incandescent appliance-type bulb(s) ONLY.
SHUT DOWN
1. Remove all remaining product.
2. Turn o proofer.
3. Clean the proong chamber. (See Cleaning below.)
CLEANING
1. Using a clean cloth moistened in warm, soapy water, wash the stainless steel interior of the cabinet.
Rinse with clear water and dry with a clean cloth.
2. Clean the outside daily with a clean, damp cloth.
3. Use care when cleaning around sensitive interior parts, such as probes and sensors.
4. Do not use cleaners containing grit, abrasive materials, bleach, harsh chemicals or chlorinated
cleaners. Do not use steel wool on stainless steel surfaces. Never spray down the proofer with water,
steam or power wash.
5. Be cautious with new or improved cleaning formulas; use only after being well tested in an inconspicious
place.
SERVICE AND PARTS INFORMATION
Contact your authorized service oce for any repairs or adjustments needed on this equipment.
TROUBLESHOOTING
PROBLEM CORRECTIVE ACTION
Machine will not turn on. 1. Make sure that the power cord is plugged in.
2. Verify that the main power supply is on.
3. Contact your local authorized service office.
Machine will not heat up. 1. Verify that the temperature is set properly.
2. Contact your local authorized service office.
Machine will not humidify
air.
1. Verify that the humidity is set properly.
2. Verify that the water supply is turned on to the equipment.
3. Contact your local authorized service office.
Machine will not cool. 1. Verify that the temperature is set properly.
2. Contact your local authorized service office.
To Previous Page
Loading...
Need help?
General
