To Next Page

To Previous Page

ENUSER’S MANUAL BR20 | BR30

6.4.2. Set limits

Press and key together, it will display SEt H, use key to select SEt H or SEt L, press key

to enter, use and key to move acve digit, use key to change value, use key to clear

value. Aer you enter the value, press key to sure, press key to escape.

6.4.3. Set check weighing mode

Press and key together, it will display SEt H, use key to select bEEP , press key to enter,

press key to select ok (check mode OK), nG (check mode NG), no (no beep), press key to sure,

press key to escape.

6.4.4. Note

Checkweighing funcon only available when weight more than 20d(min).

To disable the Check-Weighing funcon enter zero into both limits by pressing the key when the cu-

rrent limits are shown then pressing ZERO/TARE to store the zero values.

6.5. ACCUMULATE OPERATE

6.5.1. Note

The scale can be set to ccumulate manually by pressing the key. See the PARAMETERS Secon for de-

tails of selecng the method using funcon P2 Coñ.

Please note before every accumulate operate, scale need return to zero, and only press key when sta-

ble, when weight less than 20d, accumulate operate will be invalid.

6.5.2. Accumulate operate

The weight displayed will be stored in memory when the key is pressed and weight is stable.

The display will show ACC1 and then the total in memory for 2 seconds before returning to normal (aer do

accumulate operate, indicator will turn on). If the oponal RS232 interface is installed the weight will

be output to a printer or PC.

Remove the weight, allowing the scale to return to zero and put a second weight on. Press key, the

display will show ACC 2 and then the new total.

Connue unl all weights have been added.

6.5.3. Memory recall

The view the totals in memory press key.

6.5.4. Memory clear

To clear the memory, just press and together.

6.5.5. Automatically accumulate

Press key during selfchecking, enter seng mode, press key unl display show P32Coñ, press

key to enter, press key to select , press key to sure, display will show current RS232 mode,

press key to select Auto. Aer you set, Auto indicator on.

Press weight on plaorm, aer stable, you will hear beep on twice, you can add or remote weight now,

scale will beep on again aer stable, at last, remove all weight on plaorm, the last weight value will store

in memory.

6.6. ANIMAL SCALE

Let the animal on the plaorm, aer some second, if reading data change not a lot, you can hear beep

sound and reading data will be locked.

Baxtran BR20 User Manual

Questions and Answers: