35
ENUSER’S MANUAL BR40
5. DISPLAY
The LCD display screen will show a value and a unit on the right of the digit. In addition there are four indicators for TARA (TARE): gross weight
(Gross), ZERO (ZERO) and for low battery.
STABILITY SYMBOL PIECES
LOW BATTERY SYMBOL
CKECKING WEIGHT SYMBOL WEIGHT UNITIES
6. OPERATIVE
6.1 KEY AUTO-ZERO
You can press the e key at any time to set the zero point from which all the other weighings and countings are measured, within +/-2%
of power up zero. Usually, this will only be necessary when the platform would be empty. When the zero point will be obtained the indicator
will show zero.
The indicator has an automatic rezeroing function to account fewer deviatons or accumulation of material on the platform. However you may
need to press the
key to rezero the indicator if small amounts of weight are shown when the platform is empty.
6.2 TARING
Zero the scale by pressing the , key if necessary. The zero indicator will be on.
Place a weight on the platform, a value for its weight will be displayed.
Press the
key to tare the scale. The weight that was displayed will be stored as the tare value and that value will be substracted from the
display, reducing to zero the display. The “NET” indicator will be on. When a product is added only the weight of the product will be shown.
The scale could be tared a second time if another type of product is be added to the first one. Again only the weight that would be added after
taring will be displayed.
When the container is removed a negative value will be shown. If the scale was tared just before removing the container this value is the gross
weight of the container plus all product that was removed. The zero indicator will be also on because the platform is back to the same condition,
it occurs when the
key was pressed for the last time.
To Next Page
Loading...
Need help?
General
