7
ENENUSER’S MANUAL BW
5. ÉCRAN
The LCD display will show a value and a unit to the right of the digits. In addition there are labels for TARE, GROSS weight, ZERO
and for Low battery
HI
LO
GROSS
TARE
ZERO
888888
g/pcs
oz
tk
lb
OK
Stability Symbol
Checkweighing Symbols Weighing Units
Parts Counting Units
Low Battery
Symbol
6. OPERATION
6.1. ZEROING THE DISPLAY
You can press the key at any time to set the zero point from which all other weighing and count ing is measured, within 4% of
power up zero. This will usually only be necessary when the platform is empty. When the zero point is obtained the display will show
the indicator for zero.
The scale has an automatic rezeroing function to account for minor drifting or accumulation of material on the platform. However you
may need to press the key to rezero the scale if small amounts of weight are shown when the platform is empty.
6.2 TARING
Zero the scale by pressing the key if necessa ry. The zero indicator will be on.
Place a container on the platform, a value for its weight will be displayed.
Press the key to tare the scale. The weight that was displayed is stored as the tare value and that value is subtracted from the
display, leaving zero on the display.
The “TARE” indicator will be on. As product is added only the weight of the product will be shown.
When the container is removed a negative value will be shown. If the scale was tared just before removing the container this value is
the gross weight of the container plus all product that was removed. The zero indicator will also be on because the platform is back to
the same condition it was when the key was last pressed.
To Next Page
Loading...
Need help?
General
