Baxtran Super SS Series - Display Messages; Operation Guide; Preparation and Setup; Turning On and Off

ENG
FR ESP
User’s Guide Top Loading scale Model Super SS
2.2
DISPLAY MESSAGES
dc x.xx
------
AdC
-BAtLo-
_
C End
Err-0
Err-1
Err-2
Err-3
Mean the voltage of battery is x.xx V.
Show this as the weight over 100% FS+9e, with the ding sounding, this means over load, reduce
the weight.
As the A/D change overflowing, display shows this with the ding sounding.
The voltage is lower. You can use a short while and charge immediately.
Recharge is end.
Loadcell bad connected or A/D error
Calibration switch placed at OFF during calibration
No enough sample (on piece counting mode)
Calibration weigh too small
3. OPERATION GUIDE
3.1. PREPARATION
Adjust the base foot, watch the level, make the pan in horitzontal.
3.2.1. Turn on:
Press the ON/0 key, the ding sound, it displays version No. and the battery voltage level and 9, 8,
7, ..., 1, 0, the “0”. led lighting. Now the scale is in a working state.
3.2.2. Turn off:
Long-press OFF key.
3.2.3. Auto
-
off:
After 10 minutes in zero, scale will auto-off.
3.2.4. Low voltage auto
-
off:
When the voltage lower than 5.6V, then power-off.
3.2. TURN ON OR TURN OFF
3.3.
ZERO
When without taring the weight display is ≤ 4% Max. capa., press the ON/0 key, the display shows “0”,
the 0 led lighting.
Put weight to pan.
3.4. WEIGHING
3.5.
T
ARE
WEIGHING
Press the T key, the weight display is “0”, the 0 led off, the Tled
lighting. Pick up the weight, the weight
display is negative, the 0 lighting, press the T key, the T led off.
3.6. SAVE POWER FUNCTION
3.7. BATTERY INDICATE
Zero after 40 seconds, auto save power, shows “o”. Put a weight start weighing.
Battery led: means voltage higher than 6.3V, means voltage between 6V and 6.3V; means
voltage lower than 6V.
12