Need help?Do you have a question about the Bay Tek Games Crank It Revolution and is the answer not in the manual?
General| Manufacturer | Bay Tek Games |
|---|---|
| Model | Crank It Revolution |
| Category | Arcade Game Machines |
| Players | 1 |
| Bill Acceptor | Optional |
| Display | LCD |
| Power Requirements | 120V, 60Hz |
| Lighting | LED |
| Sound | Stereo |
Introduction to the game and its features.
Procedure for checking the game for any damaged, loose, or missing parts.
Details on game weight, dimensions, power requirements, and operating conditions.
Guidelines for safe operation, handling, and maintenance of the game.
List and description of the available menu options for game settings.
Setting the number of credits awarded for each play of the game.
Understanding and selecting different ticket payout configurations.
Adjusting the maximum jackpot amount awarded in the game.
Adjusting the audio volume during active gameplay.
Adjusting the audio volume when the game is not in play.
Setting the speed of the spinning wheel for gameplay.
Configuring the game's printer for ticket dispensing.
Wiring layout for the AANEWGEN1 main board.
Wiring connections for the marquee controller board.
Wiring for the optional dual printer control board.
Specific connector pinouts for power, speakers, and lighting.
Pinouts for ticket dispensers, low ticket switch, and wheel solenoids.
Pinouts for sensors, menu buttons, and wheel solenoids.
Pinouts for coin mechs, DBAs, menu buttons, and wheel sensors.
Connections from the main board to marquee components.
J18 connector pinouts for printer wiring options.
Troubleshooting steps for power-related issues.
Steps to resolve issues with the bill acceptor.
Troubleshooting steps when the game does not accept coins.
Resolving problems with scoring and game feedback.
Steps to correct incorrect ticket payouts.
Troubleshooting the 'LOW TKTS' message.
Steps to resolve issues when the game has no audio output.
Resolving problems with ticket dispensing or incorrect amounts.
Troubleshooting steps when the game wheel does not spin.
Resolving issues where the solenoid remains engaged.
Procedure for adjusting the wheel sensor for accurate readings.
Instructions for cleaning the game's exterior and internal surfaces.
Pin assignments for SPI output and Chase lights.
Pin assignments for low side and high side driver circuits.
Pin assignments for TTL logic signals.
Pin definitions for solenoids and RGB game lights.
Pin definitions for ticket dispensers and game inputs.
Pin definitions for service buttons and game sensors.
Pin definitions for the Bill Acceptor (DBA) inputs.
Details on repair and advance replacement for circuit boards.
Guidance on how to get the most out of technical support.
Details on game warranty coverage and terms.
Information on charges and procedures for non-warranty repairs.
To Next Page