Bbagua CERAMIC PILOT 2.0 - Page 75

MANUAL DE INSTRUCCIONES | 75
EN
Regeneration: setting cycle times. (DO NOT MODIFY)
The times of the regeneration cycles have been pre-programmed by the manufacturer of
the water softener. However, you can modify them in the advanced programming mode as
follows.
Setting the rst cycle (Backwash) (the time must appear on the display)
From the previous state, press the DOWN key again until program 2 appears on the
screen, which is the duration of the Backwash.
Press the “menu/conrm” button to set the rst cycle. With the help of the UP and DOWN
buttons, indicate the duration of the backwash of your water softener. (According to
Annex I).
Press “menu/conrmation” to conrm.
Setting the second cycle (Brine suction)
Press the DOWN key to set the second cycle. The indicator light will mark program 3,
which corresponds to the minutes of “Brine aspiration”.
Press the “menu/conrmation” button to set the second cycle. With the help of the UP and
DOWN buttons, specify the Brine Aspiration time of your water softener. (According to
Annex I).
Press “menu/conrmation” to conrm.
Setting the third cycle (Tank lling)
Press the DOWN button to set the third cycle. The indicator light will indicate program 4,
which corresponds to the “Brine Loading” time.
Using the “menu/conrmation” button, and with the help of the UP and DOWN keys, set
the brine loading time of your water softener. (According to Annex I).
Press “menu/conrmation” to conrm.
Setting the fourth cycle (Quick wash)
Press the DOWN button to set the fourth cycle. The indicator light will mark program 5,
which corresponds to the minutes of “Quick-Wash”.
Using the “menu/conrmation” key, and with the help of the UP and DOWN keys mark the
quick wash time. (According to Annex I).
Press “menu/conrmation” to conrm.