INSTRUCTION MANUAL | 67
EN
5. INSTALACIÓN
5.1. INSTALLATION WARNINGS
- The water softener must not be tilted during transport, installation or use.
- Install the water softener on a at surface that can support the weight of more than 300
kg/m
2
. Likewise, it must have supply and drainage water outlets in its vicinity, as well as a
socket for its electrical connection.
- The water softener is normally installed at the general water inlet. If the water softener is
installed outside the home, it must be protected from inclement weather to prevent it from
deteriorating.
It should be taken into account that its installation requires:
> 3/4” water inlet.
> Drain 16 mm diameter.
> 5 amp single-phase plug.
To Next Page
Loading...