INSTRUCTION MANUAL | 79
EN
8. MAINTENANCE
Before maintenance, close the general input key or leave the valve in the by-pass position.
The use of detergents or chemicals that may damage the equipment is prohibited.
Wipe dust o the surface of the equipment with a damp cloth, and prevent water from
reaching the electronic components and causing damage to the valve.
Disassembly: Before disassembly, the device must be in the recommended cycle
according to the maintenance operation to be performed.
Disassembly top cover
Press inward the belt and out the
base of the cover, performing the
same operation on the front.
Pull the cover up and separate it
from the back.
Disassembly by-pass
Remove the by-pass clips, uninstall
the by-pass backwards, unscrew
the hex nut, remove the brine tube
(with) connector, remove the ow
controller from the drain, loosen the
clamp and pull the drain pipe.
Valve disassembly
Take the valve key and unscrew
the salt tank collar valve.
Inner emptying
Remove the elements inside the
cabinet, to make room to the tank.
Removal of resin tank
Use a special handle and press it to the neck of the
bottle to pull it up. Then remove the resin tank.
To Next Page
Loading...