STEP 3: Attachframe(R)to stationarylegs(G)by inserting2 staionary,legbolts(i)
through2 fiber washers (8), stationary legs (G) and screw 2 hex nuts (I 0)Attach frame (R)
to wheel legs (H) by inserting the long axle (Q)through wheel (J), plastic washer (7), wheel
leg (H), t_ame (R), wheel leg (H), plastic: washer (7) and wheel (J). Screw on 2 wheel hex nuts (6).
Screw casters (F) Ohm stationary' legs (G). Cover hub caps (K) onto both wheels (J).
Do not fully tighten until finishing the grill assembly.
Customer Service_ 1-866-561-0731
To Next Page
Loading...
