BCI Capnocheck Plus - Page 8

Chapter 1: introduction
Cautions
Notes
combinations of equipment must be in compliance with IEC 601-1-1 systems
requirements. Anyone connecting additional equipment to the signal input port
or signal output port configures a medical system, and, therefore, is responsible
that the system complies with the requirements of the system standard IEC
601-1-1.
CAUTION: Ensure the device’s AC rating is correct for the AC voltage at
your installation site before using the monitor. The monitor’s AC rating is
shown on the external power supply. If the rating is not correct, do not use the
monitor; contact BCI International’s service department for help.
CAUTION: This device is intended for use by persons trained in professional
health care. The operator must be thoroughly familiar with the information in
this manual before using the monitor.
CAUTION: Do not allow water or any other liquid to spill onto the monitor.
Unplug the external power supply from the monitor before cleaning or
disinfecting the monitor.
CAUTION: Pressing front panel keys with sharp or pointed instruments may
permanently damage the keypad. Press front panel keys only with your finger.
CAUTION: Do not disassemble unit, not user serviceable. Refer to qualified
service personnel.
NOTE: Dyes introduced into the bloodstream, such as methylene blue,
indocyanine green, indigo carmine, and fluorescein, may cause an inability to
determine accurate SpO, readings.
NOTE: Any condition that restricts blood flow, such as use of a blood pressure
cuff or extremes in systemic vascular resistance, may cause an inability to
determine accurate pulse and SpO; readings.
NOTE: Operation of this device may be adversely affected in the presence of
strong EM or RF sources, such as electrosurgery equipment.
NOTE: Operation of this device may be adversely affected in the presence of
computed tomograph (CT) equipment.
1-4
Capnocheck Plus Service Manual