BCS PowerSafe 770HY - Operation; To Stop Engine

BCS 770HY Two Wheel Tractor Power Unit
Page 18 TWT770HY/PU/0221
Operaon
See g. 2 on page 11.
Use handlebar adjuster (G) to set handlebar height.
Hold the handlebar and pull up the clutch lever (C).
Depress the OPC lever (A) and select the correct working speed using the gear lever (D).
Ensure forward/reverse lever is in the correct posion to move forward (L):
If the handlebars are posioned over the engine then this lever should be in the fully back posion.
If the handlebars are posioned over the implement then it should be in the fully forward posion.
Engage drive to the working implement by using the PTO lever (E):
If the handlebars are posioned over the engine then pull the PTO lever (E) towards you.
If the handlebars are posioned over the implement then push the PTO lever (E) away from you.
Release clutch lever (C) slowly and fully, keeping the red machine stop lever depressed as the machine will
stop if released.
Move the throle lever to the correct posion for the implement you are operang - please refer to the
Implement Manual.
Commence work
Close the throle (F).
Engage clutch lever (C).
Locate gear lever (D) in neutral posion.
Disengage drive to the digging knives by pulling the PTO lever (E) backwards.
Release clutch lever (C).
Release the OPC lever (A) completely.
Move the engine stop lever (B) to posion O ‘STOP’.
WARNING: THE EXHAUST COVER MAY BE HOT - DO NOT TOUCH.
To Stop Engine