TP/TA User Guide 12
9 Tool Address
Each TP/TA unit should be assigned an independent one of eight tool addresses.
This is important in a workshop where more than one power tool is being used at
the same time.
This information is used by the ‘iVAC Pro Switch’ to enable it to know the status
of each individual power tool in a system.
The Tool Address is set by means of the Program Switches 4, 5 and 6.
* factory setting
Tool Address S4 S5 S6
1 on off off
2 off on off
3 on on off
4 off off on
5 on off on
6 off on on
7 on on on
8 * off off off
To Next Page
Loading...