TP/TA User Guide 16
12 System Test
Turn off the power tool. Set the Mode Switch to AUTO.
Turn the power tool on.
The Activity LED should flash for approx. 3 seconds and then go to an ON state.
Turn the power tool off.
The Activity LED should flash for approx. 3 seconds and then go to an OFF state.
At this point TP/TA should be communicating with the ‘iVAC Pro Switch’ that in
turn controls the dust collector.
13 ‘Tool Plus/Tool Advantage’ Features
Plastic housing is 3.75” x 2.5” x 1.75” (95 x 63.5 x 44.5 mm) ABS 94V0 plastics.
Input power cord is 10 ft (3 m) long with a USB power plug.
Three Modes of operation. AUTO – OFF - ON.
Programmable System Address.
Programmable Tool Address.
Preset able Sensitivity.
Activity LED.
External Trigger Mode (Tool Advantage Only).
To Next Page
Loading...