TP/TA User Guide 9
CAUTION:
It is important to NOT change the Mode Switch while TP/TA is transmitting. You
must wait until the LED stops flashing before moving the Mode Switch from Auto
to OFF, OFF to ON, ON to OFF or OFF to AUTO.
NOTE
When in OFF or ON Mode the LED indicates how much current is flowing to the
power tool. This indication is dependent on the setting of the sensitivity control.
Once the sensitivity of the TP/TA has been properly set up, see section 11 below,
LED = Off Power tool is off
LED = Flashing The LED has two flash rates, both rates are faster than the
Flash rate when TP/TA is transmitting RF commands.
LED = ON Power tool is on
To Next Page
Loading...