Bdcom S2528-B User Manual

S2528-B Hardware Installation Manual
- 7 -

When you install the machine box at the open cabinet, prevent the frame of
the cabinet from blocking the airway of the machine box.

Ensure that nice ventilation is provided for the devices installed at the bottom
of the cabinet.

The clapboard separates exhaust gas and inflow air, and boost cool air to
flow in the machine box. The best location of the clapboard is decided by the
air flow mode in the machine box, which can be obtained through different
location tests.
2.3.4 Power Requirements
Make sure that the power supply has nice grounding and the power at the input
side of the switch is reliable. The voltage control can be installed if necessary. At
least a 240 V, 10A fuse or a breaker is provided in the phase line if you prepare the
short-circuit prevention measures for a building.
Caution:
If the power supply system does not have good grounding, or the input power
disturbs too much and excessive pulses exist, the error code rate of communication
devices increases and even the hardware system will be damaged.
2.4 Installation Tools and Device
The tools and devices to install the S2528-B switch are not provided by the
S2528-B switch. You yourself need to prepare them. The following are the tools and
devices needed for the typical installation of the S2528-B switch:

Screwdriver

Static armguard

Bolt

Ethernet cable

Other Ethernet terminal devices

Control terminal

Bdcom S2528-B Specifications

General

Brand	Bdcom
Model	S2528-B
Category	Switch
Language	English