S2528GX Hardware Installation Manual
- 18 -
1 PWR Power LED
If the switch is powered on, the LED is
on.
2 SYS System LED
If the LED is always on, the system is
being started.
If the LED flickers, the system works
normally.
3 LINKACT LED at the top of each port
If the LED is always on, the link on the
port is normal.
If the LED is off, the port is not
connected.
Copyright Claims
Without the written approval of , any person or group cannot transcribe, copy or change partial or
all contents of this manual, and must not broadcast it in any manner.
Trademark claims
Trademarks, product names, service names and company names, which are written in this manual
but do not belong to , belong to their owners respectively.
Disclaimer of warranty
provides no evident or hinted guarantee towards the contents of this manual. In no event, except
for ’s breach of law, shall be liable for incidental, consequential, indirect or special damages of
any kind or for loss of profits or revenue or loss of business arising out of or relating to this manual.
Note: Customer shall not be notified of this manual’s content amendments.
To Previous Page
Loading...
Need help?
General
