Operation
MAB 480 22
Drilling with the machine
Drilling with twist drills
Proceed as follows when drilling with twist drills:
Push twist drills with MK taper from below into the morse
taper (3) of the machine.
Position the machine at the working location, align it and
switch on the magnetic clamps.
Select the appropriate speed and switch on the machine.
NOTE
Observe the following instructions when drilling with twist drills:
► Under high pressure, the drill can glow out and the machine
can be overloaded.
► When working overhead, use the high-performance grease
spray ZHS 400. Spray the drill with grease spray before drill-
ing. Repeat the procedure when drilling deep holes.
► Pay attention to a regular chip discharge. With larger drilling
depths, the chip may break.
To Next Page
Loading...
