To Next Page
J
Jason MartinAug 11, 2025
What to do if my BDS MAB 800 Drill motor won't start or stops?
- CConnie DeanAug 11, 2025
If the motor of your BDS Drill doesn't start or stops unexpectedly, check the following: * Ensure the plug is properly inserted into the socket. * Reset the automatic circuit breaker if it has tripped. * Verify that the magnetic clamp is switched on. * Allow the machine to cool down if the internal safety switch activated due to overheating. * Select the direction of rotation. * If the torque cut-out has tripped, switch the machine off and on again.
General
