8
Safety
MAB 800 / MAB 840
■ Do not leave the machine unsupervised during operation.
■ Store the machine in a dry, temperate location out of the reach
of children.
■ Do not leave the machine standing outdoors and do not ex-
pose it to moisture.
■ Make sure that your work area is suciently lit (>300 Lux).
■ Do not use low power machines for heavy working.
■ Make sure that your workplace is clean.
■ Keep the machine clean, dry and free of oil and grease.
■ Follow the instructions on lubricating and cooling the tool.
Electric shock hazard
DANGER
Danger to life by electric shock!
Contact with live wires or components could lead to seri-
ous injury or even death!
Observe the following safety precautions to avoid electric
shocks:
► Do not open the housing of the machine. Risk of electric
shock if live terminals are touched.
► Never immerse the machine or the plug into water or other
liquids.
► Use only extension leads or cable drums with a cable cross-
section of 1.5 mm².
► Only use extension leads that are approved for the place of
work.
► Check the condition of the extension lead regularly and
replace if damaged.
► Avoid direct body contact with grounded parts (e.g., tubes,
radiators, steel girders) to reduce the risk of electric shock in
the event of a defect.
► When using the machine outside or in a humid environment,
an RCD (residual circuit device) must be used.
To Next Page
Loading...
