BDS MAB 800 - Operation; Activating;Deactivating Magnetic Clamp

20
Operation
MAB 800 / MAB 840
Operation
Activating/deactivating magnetic clamp
Activating magnetic clamp
CAUTION
► Switch on the magnetic clamp only when the machine is
standing on a magnetic substrate to avoid overheating of the
magnet.
 Turn on switch (22). The indicator light in switch (22) comes
on.
 Check the magnet clamping force at the magnet indica-
tor (24). When the magnet clamping force is su󰀩cient, the
MAGNET POWER indicator light (24) is green. If the MAG-
NET POWER indicator light (24) is red, there is not su󰀩cient
magnet clamping force available.
CAUTION
► The maximum magnet clamping force is only available after
switching on the motor.
Deactivating magnetic clamp
 Secure the machine at the handle (10) to prevent the ma-
chine from slipping o󰀨 the surface.
 Turn o󰀨 switch (22). The indicator light in switch (22) goes
out.