What to do if BDS Drill motor doesn't start or stops?
If the BDS Drill motor doesn't start or stops during operation, there might be a few reasons. First, check if the plug is properly inserted into the socket and insert it if it is not. Second, ensure that the circuit breaker is switched on. Finally, verify that the magnetic clamp is also switched on.
Why is the magnetic clamp not working on my BDS Drill?
If the magnetic clamp on your BDS Drill isn't functioning, it could be due to a couple of reasons. First, make sure the magnet is switched on. If it is, check whether the surface you're working on is magnetic. If not, use a suitable magnetic base.
What to do if the circuit breaker trips when using my BDS MABasic 200?
If the circuit breaker trips when using your BDS Drill, it might be because too many appliances are connected to the same power circuit. Try reducing the number of appliances on the power circuit. If the problem persists, the machine may be defective.
How to fix a BDS MABasic 200 lubrication system that isn't working?
If the lubrication system on your BDS Drill isn't working, there are several things to check: * First, ensure that there is enough lubricant available and top it up if necessary. * Second, verify that the lubricant tap is open. * Finally, inspect the connecting nipple for any clogs and clean the tank and nipple if needed.
What to do if the BDS Drill motor does not start or stops?
If the motor of your BDS Drill doesn't start after pressing the ON/OFF switch, or it stops during operation, there are a few potential causes. First, ensure the plug is properly inserted into the socket. Second, check if the automatic circuit breaker has tripped and switch it back on if necessary. Lastly, verify that the magnetic clamp is switched on.
Why does the automatic circuit breaker trip when using my BDS Drill?
If the automatic circuit breaker in the electrical distribution board trips when using the BDS Drill, it could be due to too many appliances connected to the same power circuit. Try reducing the number of appliances on the power circuit. If the problem persists, the machine might be defective, and you should contact customer service.
How to fix the lubrication system if it does not function in BDS Drill?
If the lubrication system of your BDS Drill is not functioning, it could be due to several reasons. First, check if there is enough lubricant available and top it up if necessary. Second, ensure that the lubricant tap is open. Finally, inspect the connecting nipple for any clogs and clean the tank and nipple if needed.
What to do if the magnetic clamp does not function on my BDS Drill?
If the magnetic clamp on your BDS Drill isn't working, first ensure that the magnet is switched on. If it still doesn't function, the surface you're trying to adhere to might not be magnetic. In this case, use a suitable base.
Defines the machine's specific purpose and prohibits improper use.
Lists essential precautions for safe operation, covering electrical and general safety.
Details critical steps to prevent electric shock during machine operation.
Outlines measures to avoid injuries from improper handling or operation.
Step-by-step instructions and safety warnings for inserting drill bits.
Procedures for safely activating and deactivating the magnetic clamp.
How to switch the machine's motor on and off using the designated switch.
Procedures for safely resolving blockages caused by broken tools or swarf.
Steps to take for other types of blockages encountered during operation.
A table listing common machine faults, their possible causes, and solutions.
To Next Page
General
