BDS MAB 480 - User Manual

Questions and Answers

C
Carolyn CruzAug 4, 2025
What to do if the BDS Drill motor does not start or stops during operation?
- N
  Noah KellyAug 4, 2025
  If the BDS Drill motor doesn't start or stops unexpectedly, check the following: Ensure the plug is properly inserted into the socket. Verify that the automatic circuit breaker hasn't tripped and switch it on if needed. Make sure the magnetic clamp is activated. If the machine has overheated, allow it to cool down. Also, confirm that the direction of rotation is correctly preselected.
C
christopher10Aug 10, 2025
Why does the automatic circuit breaker trip when using my BDS MAB 480 Drill?
- C
  Connor FryAug 10, 2025
  The automatic circuit breaker might trip because too many appliances are connected to the same power circuit. Try reducing the number of appliances on the circuit. If the problem persists, contact After-sales Service.
L
Lisa ThompsonAug 18, 2025
What to do if the magnetic clamp on my BDS MAB 480 does not function?
- E
  Emily DixonAug 18, 2025
  If the magnetic clamp isn't working, first ensure that the magnet is switched on. If it is on, check that you are using a suitable magnetic base. If the surface is not magnetic, the clamp will not function.
A
Amber KellyAug 26, 2025
How to fix a BDS Drill lubrication system that isn't working?
- P
  Perry ArmstrongAug 26, 2025
  If the lubrication system isn't working, start by checking if there is enough lubricant; if not, top it up. Then, make sure the lubricant tap is open. Lastly, inspect the connecting nipple for any clogs and clean the tank and nipple if necessary.