33
1. Open the water inlet at the rear of the air cooler.
2. Carefully fill the water tank with clean water using a watering can or
similar container. Pay attention to the fill level on t h e front of the
water tank:
MIN mark The water tank must be filled above the MIN mark for the
pump to function correctly
MAX mark The water tank must not be filled above the MAX mark,
as otherwise water could enter the inside of the appliance and
damage electronic parts.
3. Make sure that the outside of the appliance is not damp or wet and
wipe it down if necessary.
4. Then close the water inlet flap.
REMOTE CONTROL
PREPARING THE REMOTE CONTROL - INSERTING OR REPLACING
BATTERIES
Please note the following instructions:
Initial operation:
1. To operate the remote control for the first time, please pull
the plastic cover out of the battery compartment on the back
of the remote control.
Change the battery:
1. Pull out the battery holder on the back of the remote control
and remove the old battery from the holder:
2. Now insert a new CR2025 battery, always paying attention to the
polarity markings (+/-) on the battery and the battery holder.
3. Then push the battery holder fully back into the remote control.
To Next Page
Loading...
