Be Cool pivot - Introduction to Seat Functions; Rotation Function; Group 0+1 (0-18 kg) Rear Facing Installation; ISOFIX Installation for Group 0+1

EN
62
1
2
INTRODUCTION TO THE SAFETY SEAT
FUNCTIONS
Rotation function
1 Fitted in forward facing position
5 Fitted in rear facing position
As shown in gure 1, use your thumb to pull the rotation
control handle in order to turn the child seat round. It can
be turned both ways (see gure 1, 2, 3, 4 and 5). When
you have nished turning it, release the rotation control
handle and the “OK” sign will be displayed (see gure 5).
Important: On car journeys, the safety seat must
not be used in a sideways position and must not be
rotated. It must only be tted in either the forward
facing position (gure 1) or the rear facing position
(gure 5).
INSTALLATION FOR GROUP 0+1 (0-18 KG)
IN THE REAR FACING POSITION
Note:
1. The safety seat is only suitable for use in the listed ve-
hicles tted with ISOFIX anchor systems and approved
by ECE regulation No. 14.
2. Correct installation for group 0 + 1 is in the rear facing
position and is suitable for children from 0 to 18 kg.
3. This child safety seat for group 0 + 1 only has one seat-
ing position which is level 1.
4. The child safety seat for group 0 + 1 must not be tted
into seats equipped with an airbag.
5. Important: If the child weighs less than 9 kg, this child
safety seat must not be installed in the forward facing
position.
6. Important: On car journeys, the safety seat must not
be used in a sideways position.
7. The group 1 insert is suitable for use with children who
weigh between 9-12 kg. The group 0+ insert should be
tted with the group 1 insert and this is then suitable for
children who weigh less than 9 kg.
8. In the rear facing position, add the anti-collision
sponge; in the forward facing position, remove the an-
ti-collision sponge.
a- ISOFIX installation for group 0+1
Step 1: as shown in gure 1, turn the child safety seat to
the rear facing position (see the rotation function section
on page 8). Then, pull the seat position adjustment han-
dle to set it to level 1.
Step 2: as shown in gure 2, release the ISOFIX connec-
tor. Pull the ISOFIX adjustment handle and the ISOFIX