Page 4 of 8 75.5892.04 KEYPADS 20201007
PROGRAMMING (cont.)
GETTING STARTED
ADMIN CODES
DOOR MODE
ENTER SETUP MODE
Enter the default administration code (1234) twice (i.e. 1234 + 1234) to enter
“setup” mode.
Mode LED will turn red and a long beep will be heard.
Press the “#” key to exit “setup” mode. Mode LED will turn green.
DOOR MODE
MODIFY ADMIN CODE
Enter “setup” mode.
Press the star (*) key and then “3”. Mode LED will flash red.
Enter a new 4-digit number (0000 – 9999) twice to set the new admin code.
Press “#” to exit “setup” mode. Mode LED turns green.
CHANGE LENGTH OF ADMIN CODE
Changing the admin code length will delete all existing user codes.
Changing the admin code length will reset the admin code back to a sequential number (similar to that
in step 1a), consiting of the correct amount of digits (e.g. if the admin code length is changed to 6 digits,
the admin code defaults to “123456”).
Enter “setup” mode.
Press the star (*) key and then “9”. Mode LED will flash red.
Press “0” and then “4”. A short beep will sound. Mode LED will turn red.
Enter the length of the admin code in digits, ranging from “2” to “6” (“2” is the minimum code
length, and “6” is the maximum).
• one beep = admin code length successfully changed
• three beeps = admin code length is equal to existing length
Press “#” to exit “Admin code length setup” mode. Mode LED remains red.
Press “#” again to exit “setup” mode. Mode LED turns green.
To Next Page
Loading...